Data Out is the Computer or Daisy chain Port. TTL Kenwood and active high for Radio CTS 5. PINOUT of 9 pin SUBD DATA IN CONNECTOR 1. This Port has a Baud Rate range of 1200 to 57600. This was done so it only required a cable change to connect to a different radio type. This port has a unique pin-out requiring non-standard cables to connect to the Radio. The Transceiver Interface will only control the Steppir when it is in the General Frequency Mode or AutoTrack with SDA. It is attached to the driver board at the back of the controller and has two 9 pin sub-D connectors, Data in and Data out. Connections The Transceiver interface is mounted inside the SteppIR controller. MicroHam Station controllers For a more detailed list and cabling information refer to the table at the end of this document. Yaesu FT1000D (requires IFF232) (can be 25 pin or 9pin) 11. Yaesu FT897 – using the FT847 setting (requires the Yaesu CT-62) 8. Yaesu FT857 (requires the Yaesu CT-62) 7. Kenwood – All Kenwood’s with a RS232 interface. For Radio control see the Data In connector description. Transceiver interface Operation for Steppir For Direct computer control see the Data Out connector description.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |